happy printing
← Resources

LEVEL 4 / Design

Design, test, repeat

Write down one thing the part must do before you open CAD.

HAPPY PRINTING / QUICK REFERENCEDesign, test, repeat
  1. Set the goal

    Decide what the part needs to do.

  2. Print a sample

    Test fit and function.

  3. Refine it

    Change what the test revealed.

Good functional prints start with a measurable requirement. Use a small cable clip as a worked example: it must accept a particular cable, stay attached in its intended location and survive normal handling. A beautiful render alone cannot establish any of those things.

01

Describe the fit before modeling

What this step changes

Printers and materials introduce variation. Designing to the nominal cable diameter with no clearance can create an attractive clip that will not assemble.

Try it step by step

  1. Measure the cable and mounting location at several points. Note whether the clip must slide, grip, snap or be removed regularly.
  2. Sketch the critical section and choose how you will test it. For a clip, record cable fit and how the mounting feature will attach.
  3. Pick an appropriate material for the environment. PLA may work for an indoor prototype; heat, repeated flexing or outdoor use can require a different material and design.

How to judge the result

Your requirement should be observable: “the cable seats without damage and stays in place during normal use” is better than “make it strong.” Do not rely on an untested print for safety-critical loads.

02

Print only the uncertain feature

What this step changes

A short test of the jaw, hole or joint costs less than a whole assembly. Matching the final orientation makes the test meaningful because layer direction affects behavior.

Try it step by step

  1. Model a small section containing the critical opening and enough surrounding wall to behave like the finished part.
  2. Create a few labeled clearance variants. Use modest differences suited to the feature and your printer; there is no universal clearance that fits every process.
  3. Print them together with the same material and intended orientation. After cooling, try the actual mating part without forcing it.

How to judge the result

Record which variant fits and whether it cracks, flexes excessively or marks the cable. A loose fit can come from geometry, shrinkage or extrusion calibration. Diagnose the cause before applying a global scale correction.

03

Revise deliberately and verify the complete part

What this step changes

A successful coupon establishes a fit, but adding the rest of the part changes loads, supports and printing behavior. The final assembly still needs testing.

Try it step by step

  1. Update the model with the successful dimension and keep a version history. Change one important variable per iteration.
  2. Print the full part, inspect support-contact areas and try the real assembly in its intended position. Confirm that fasteners and tools can reach it.
  3. Check again after representative use. Save the model, slicer project, material and observations so you can reproduce the result later.

How to judge the result

The winning version is the one that meets the requirement repeatedly. If it fails across layer lines, revisit orientation and geometry before simply increasing infill. The infill and supports guides explain the tradeoffs.